Cisco 300 Series User Manual

802.1X Commands
73 OL-32830-01 Command Line Interface Reference Guide
2
Command Mode
Global Configuration mode
User Guidelines
Any combination of the keywords are allowed. At least one keyword must be
configured.
A rate limit is applied to the traps: not more than one trap of this type can be sent in 10
seconds.
Example
The following example enables sending traps when a MAC address fails to be
authorized by the 802.1X mac-authentication access control .
switchxxxxxx(config)# dot1x traps authentication failure 802.1x
2.27 dot1x traps authentication quiet
Use the dot1x traps authentication quiet Global Configuration mode command to
enable sending traps when a host state is set to the quiet state after failing the
maximum sequential attempts of login. Use the no form of this command to disable
the traps.
Syntax
dot1x traps authentication quiet
no dot1x traps authentication quiet
Parameters
N/A
Default Configuration
Quiet traps are disabled.
Command Mode
Global Configuration mode

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48