Cisco 300 Series User Manual

Address Table Commands
OL-32830-01 Command Line Interface Reference Guide 154
5
5.10 bridge multicast ipv6 ip-address
To register an IPv6 Multicast address to the bridge table, and statically add or
remove ports to or from the group, use the bridge multicast ipv6 ip-address
Interface (VLAN) Configuration mode command. To unregister the IPv6 address,
use the no form of this command.
Syntax
bridge multicast ipv6 ip-address
ipv6-multicast-address [[add | remove] {ethernet
interface-list |
port-channel port-channel-list}]
no bridge multicast ipv6 ip-address ip-multicast-address
Parameters
• ipv6-multicast-address—Specifies the group IPv6 multicast address.
• add—(Optional) Adds ports to the group.
• remove—(Optional) Removes ports from the group.
• ethernet interface-list —(Optional) Specifies a list of Ethernet ports.
Separate nonconsecutive Ethernet ports with a comma and no spaces; use
a hyphen to designate a range of ports.
• port-channel port-channel-list —(Optional) Specifies a list of port channels.
Separate nonconsecutive port-channels with a comma and no spaces. Use
a hyphen to designate a range of port channels.
Default Configuration
No Multicast addresses are defined.
The default option is add.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
To register the group in the bridge database without adding or removing ports or
port channels, specify the ipv6-multicast-address parameter only.
Static Multicast addresses can be defined on static VLANs only.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48