Cisco 300 Series User Manual

Network Management Protocol (SNMP) Commands
881 OL-32830-01 Command Line Interface Reference Guide
45
Example
The following example displays the SNMP engine ID.
switchxxxxxx# show snmp engineID
Local SNMP engineID: 08009009020C0B099C075878
IP address Remote SNMP engineID
----------- -------------------------------
172.16.1.1 08009009020C0B099C075879
45.18 snmp-server enable traps
To enable the device to send SNMP traps, use the snmp-server enable traps
Global Configuration mode command. To disable all SNMP traps, use the no form
of the command.
Syntax
snmp-server enable traps
no snmp-server enable traps
Default Configuration
SNMP traps are enabled.
Command Mode
Global Configuration mode
User Guidelines
If no snmp-server enable traps has been entered, you can enable failure traps by
using snmp-server trap authentication as shown in the example.
Example
The following example enables SNMP traps except for SNMP failure traps.
switchxxxxxx(config)# snmp-server enable traps
switchxxxxxx(config)# no snmp-server trap authentication

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48