Cisco 300 Series User Manual

SYSLOG Commands
957 OL-32830-01 Command Line Interface Reference Guide
49
Example
The following example enables logging messages related to file copy operations.
switchxxxxxx(config)# file-system logging copy
49.5 logging buffered
To limit the SYSLOG message display to messages with a specific severity level,
and to define the buffer size (number of messages that can be stored), use the
logging buffered Global Configuration mode command. To cancel displaying the
SYSLOG messages, and to return the buffer size to default, use the no form of this
command.
Syntax
logging buffered [
buffer-size ] [ severity - level | severity-level-name ]
no logging buffered
Parameters
• buffer-size—(Optional) Specifies the maximum number of messages stored
in buffer. (Range: 20–1000)
• severity-level—(Optional) Specifies the severity level of messages logged
in the buffer. The possible values are: 1-7.
• severity-level-name—(Optional) Specifies the severity level of messages
logged in the buffer. The possible values are: emergencies, alerts, critical,
errors, warnings, notifications, informational and debugging.
Default Configuration
The default severity level is informational.
The default buffer size is 1000.
Command Mode
Global Configuration mode

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48