Cisco 300 Series

Ethernet Configuration Commands
OL-32830-01 Command Line Interface Reference Guide 416
18
Default Configuration
10% of port speed in Kbps
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
Use the storm-control broadcast enable Interface Configuration command to
enable storm control.
The calculated rate includes the 20 bytes of Ethernet framing overhead
(preamble+SFD+IPG).
Examples
Example 1—Set to specific level:
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# storm-control broadcast level 20
Example 2—Set to specific rate:
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# storm-control broadcast kbps 10000
18.28 storm-control include-multicast
To count Multicast packets in a Broadcast storm control, use the storm-control
include-multicast Interface Configuration mode command. To disable counting of
Multicast packets in the Broadcast storm control, use the no form of this command.
Syntax
storm-control include-multicast [unknown-unicast]
no storm-control include-multicast