Cisco 300 Series User Manual

Link Layer Discovery Protocol (LLDP) Commands
OL-32830-01 Command Line Interface Reference Guide 650
30
Example
The following example enables LLDP MED with the location TLV on gi13.
switchxxxxxx(config)# interface gi13
switchxxxxxx(config-if)# lldp med enable location
30.7 lldp med notifications topology-change
To enable sending LLDP MED topology change notifications on a port, use the lldp
med notifications topology-change Interface (Ethernet) Configuration mode
command. To restore the default configuration, use the no form of this command.
Syntax
lldp med notifications topology-change
{enable | disable}
no lldp med notifications topology-change
Parameters
• enable—Enables sending LLDP MED topology change notifications.
• disable—Disables sending LLDP MED topology change notifications.
Default Configuration
Disable is the default.
Command Mode
Interface (Ethernet) Configuration mode
Example
The following example enables sending LLDP MED topology change notifications
on
gi1 2.
switchxxxxxx(config)# interface gi12
switchxxxxxx(config-if)# lldp med notifications topology-change enable

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48