Cisco 300 Series User Manual

Line Commands
641 OL-32830-01 Command Line Interface Reference Guide
29
Parameters
• console—Enters the terminal line mode.
• telnet—Configures the device as a virtual terminal for remote access
(Telnet).
• ssh—Configures the device as a virtual terminal for secured remote access
(SSH).
Command Mode
Global Configuration mode
Example
The following example configures the device as a virtual terminal for remote
(Telnet) access.
switchxxxxxx(config)# line telnet
switchxxxxxx(config-line)#
29.4 speed
To set the line baud rate, use the speed command in Line Configuration mode.
To restore the default configuration, use the no form of this command.
Syntax
speed
bps
no speed
Parameters
bps—Specifies the baud rate in bits per second (bps). Possible values are 4800,
9600, 19200, 38400, 57600, and 115200.
Default Configuration
The default speed is 115200 bps.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48