Cisco 300 Series

EEE Commands
381 OL-32830-01 Command Line Interface Reference Guide
17
17.2 eee enable (interface)
To enable the EEE mode on an Ethernet port, use the eee enable Interface
Configuration command. To disable the mode, use the no format of the command.
Syntax
eee enable
no eee enable
Parameters
This command has no arguments or keywords.
Default Configuration
EEE is enabled.
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
If auto-negotiation is not enabled on the port and its speed is 1 Giga, the EEE
operational status is disabled.
Example
switchxxxxxx(config)# interface gi1 1
switchxxxxxx(config-if)# eee enable
17.3 eee lldp enable
To enable EEE support by LLDP on an Ethernet port, use the eee lldp enable
Interface Configuration command. To disable the support, use the no format of the
command.
Syntax
eee lldp enable
no eee lldp enable