Cisco 300 Series User Manual

Macro Commands
695 OL-32830-01 Command Line Interface Reference Guide
32
Examples
switchxxxxxx(config)# macro global description "set console timeout interval"
32.6 show parser macro
Use the show parser macro User EXEC mode command to display the parameters
for all configured macros or for one macro on the switch.
Syntax
show parser macro [{brief | description [interface
interface-id | detailed] | name
macro-name
}]
Parameters
• brief — Display the name of all macros.
• description [interface interface-id ] — Display the macro descriptions for all
interfaces or if an interface is specified, display the macro descriptions for
that interface.
• name macro-name— Display information about a single macro identified by
the macro name.
• detailed—Displays information for non-present ports in addition to present
ports.
Default Configuration
Display description of all macros on present ports.
If the detailed keyword is not used, only present ports are displayed.
Command Mode
User EXEC mode
Examples
Example 1 - This is a partial output example from the show parser macro
command.
switchxxxxxx# show parser macro

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48