Cisco 300 Series User Manual

Smartport Commands
OL-32830-01 Command Line Interface Reference Guide 844
44
Example
To enable LLDP globally:
switchxxxxxx(config)# macro auto processing lldp
44.9 macro auto processing type
The macro auto processing type Global Configuration mode command enables or
disables automatic detection of devices of given type. The no format of the
command returns to the default.
Syntax
macro auto processing type
smartport-type {enabled | disabled}
no macro auto processing type
smartport-type
Parameters
• smartport-type —Smartport type (range: host, ip_phone,
ip_phone_desktop, switch, router or wireless access point (ap)).
Default Configuration
By default, auto detection of ip_phone, ip_phone_desktop, switch, and wireless
access point (ap) is enabled.
Command Mode
Global Configuration mode
Example
In this example, automatic detection of wireless access points (ap) is enabled.
switchxxxxxx(config)# macro auto processing type ?
host set type to host
ip_phone set type to ip_phone
ip_phone_desktop set type to ip_phone_desktop

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48