Cisco 300 Series User Manual

IGMP Snooping Commands
OL-32830-01 Command Line Interface Reference Guide 448
21
IGMP Snooping Querier is enabled
IGMP Snooping Querier operation state: is running
IGMP Snooping Querier version: 2
IGMP Snooping Querier election is enabled
IGMP Snooping Querier address: 194.12.10.166
IGMP snooping robustness: admin 2 oper 2
IGMP snooping query interval: admin 125 sec oper 125 sec
IGMP snooping query maximum response: admin 10 sec oper 10 sec
IGMP snooping last member query counter: admin 2 oper 2
IGMP snooping last member query interval: admin 1000 msec oper 500 msec
Groups that are in IGMP version 1 compatibility mode:
231.2.2.3, 231.2.2.3
21.18 show ip igmp snooping mrouter
To display information on dynamically learned Multicast router interfaces for all
VLANs or for a specific VLAN, use the show ip igmp snooping mrouter command
in User EXEC mode.
Syntax
show ip igmp snooping mrouter
[interface vlan-id ]
Parameters
• interface vlan-id —(Optional) Specifies the VLAN ID.
Command Mode
User EXEC mode
Example
The following example displays information on dynamically learned Multicast
router interfaces for VLAN 1000:
switchxxxxxx# show ip igmp snooping mrouter interface 1000

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48