DHCP Server Commands
OL-32830-01 Command Line Interface Reference Guide 308
12
Example
The following example displays DHCP server statistics
switchxxxxxx#
show ip dhcp server statistics
DHCP server enabled
The number of network pools is 7
The number of excluded pools is 2
The number of used (all types) entries is 7
The number of pre-allocated entries is 1
The number of allocated entries is 3
The number of expired entries is 1
The number of declined entries is 2
The number of static entries is 1
The number of dynamic entries is 2
The number of automatic entries is 1
12.29 time-server
To specify the time servers list for a DHCP client, use the time-server command in
DHCP Pool Network Configuration mode or in DHCP Pool Host Configuration
mode. To remove the time servers list, use the no form of this command.
Syntax
time-server
ip-address
[
ip-address2
...
ip-address8
]
no time-server
Parameters
•
ip-address
[
ip-address2
...
ip-address8
]—Specifies the IP addresses of
Time servers. Up to eight addresses can be specified in one command line.
Command Mode
DHCP Pool Network Configuration mode
DHCP Pool Host Configuration mode
To Next Page
Loading...
