Cisco 300 Series User Manual

Quality of Service (QoS) Commands
749 OL-32830-01 Command Line Interface Reference Guide
39
A policy map contains one or more class maps and an action that is taken if the
packet matches the class map. Policy maps may be bound to ports/port-channels.
Entering the policy-map Global Configuration mode command also enables
configuring or modifying the class policies for that policy map. Class policies in a
policy map can be configured only if the classes have match criteria defined for
them.
Policy map is applied on the ingress path.
The match criteria is for a class map. Only one policy map per interface is
supported. The same policy map can be applied to multiple interfaces and
directions.
The service-policy command binds a policy map to a port/port-channel.
Example
The following example creates a policy map called Policy1 and enters the
Policy-map Configuration mode.
switchxxxxxx(config)# policy-map policy1
switchxxxxxx(config-pmap)#
39.8 class
Use the class Policy-map Configuration mode. command after the policy-map
command to attach ACLs to a policy-map. Use the no form of this command to
detach a class map from a policy map.
Syntax
class
class-map-name [ access-group acl-name ]
no class
class-map-name
Parameters
• class-map-name—Specifies the name of an existing class map. If the class
map does not exist, a new class map is created under the specified name.
• access-group acl-name —Specifies the name of an IP, IPv6, or MAC Access
Control List (ACL).

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48