Cisco 300 Series User Manual

DHCP Snooping Commands
311 OL-32830-01 Command Line Interface Reference Guide
13
13.2 ip dhcp snooping vlan
Use the ip dhcp snooping vlan Global Configuration mode command to enable
DHCP Snooping on a VLAN. Use the no form of this command to disable DHCP
Snooping on a VLAN.
Syntax
ip dhcp snooping vlan
vlan-id
no ip dhcp snooping vlan vlan-id
Parameters
• vlan-id —Specifies the VLAN ID.
Default Configuration
DHCP Snooping on a VLAN is disabled.
Command Mode
Global Configuration mode
User Guidelines
DHCP Snooping must be enabled globally before enabling DHCP Snooping on a
VLAN.
Example
The following example enables DHCP Snooping on VLAN 21.
switchxxxxxx(config)# ip dhcp snooping vlan 21
13.3 ip dhcp snooping trust
Use the ip dhcp snooping trust Interface Configuration (Ethernet, Port-channel)
mode command to configure a port as trusted for DHCP snooping purposes. Use
the no form of this command to restore the default configuration.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48