DHCP Snooping Commands
OL-32830-01 Command Line Interface Reference Guide 334
13
Example
The following example sets the minimum ARP SYSLOG message logging time
interval to 60 seconds.
switchxxxxxx(config)#
ip arp inspection logging interval
60
13.28 show ip arp inspection
Use the show ip arp inspection EXEC mode command to display the ARP
inspection configuration for all interfaces or for a specific interface.
Syntax
show ip arp inspection
[
interface-id
]
Parameters
•
interface-id
—Specifies an interface ID. The interface ID can be one of the
following types: Ethernet port or Port-channel.
Command Mode
User EXEC mode
Example
The following example displays the ARP inspection configuration.
switchxxxxxx#
show ip arp inspection
IP ARP inspection is Enabled
IP ARP inspection is configured on following VLANs: 1
Verification of packet header is Enabled
IP ARP inspection logging interval is: 222 seconds
Interface Trusted
----------- -----------
gi1
1 Yes
gi1
2 Yes
To Next Page
Loading...
