Cisco 300 Series

CDP Commands
OL-32830-01 Command Line Interface Reference Guide 206
8
Parameters
N/A
Default Configuration
Enabled.
Command Mode
Global Configuration mode
Example
This example turns off mandatory TLV validation:
switchxxxxxx(config)# no cdp mandatory-tlvs validation
8.7 cdp source-interface
The cdp source-interface Global Configuration mode command specifies the CDP
source port used for source IP address selection. The no format of this command
deletes the source interface.
Syntax
cdp source-interface
interface-id
no cdp source-interface
Parameters
• interface-id —Source port used for Source IP address selection.
Default Configuration
No CDP source interface is specified.
Command Mode
Global Configuration mode