Cisco 300 Series

Spanning-Tree Commands
OL-32830-01 Command Line Interface Reference Guide 910
46
switchxxxxxx(config)# spanning-tree mst configuration
switchxxxxxx(config-mst) # revision 1
46.26 show (MST)
Use the show MST Configuration mode command to display the current or
pending MST region configuration.
Syntax
show
{current | pending}
Parameters
• current—Displays the current MST region configuration.
• pending—Displays the pending MST region configuration.
Default Configuration
N/A
Command Mode
MST Configuration mode
Example
The following example displays a pending MST region configuration
switchxxxxxx(config-mst)# show pending
Gathering information ..........
Current MST configuration
Name: Region1
Revision: 1
Instance VLANs Mapped State
-------- ------------------------ -----
0 1-4094 Disabled
switchxxxxxx(config-mst)#