EasyManuals Logo

Cisco 300 Series User Manual

Cisco 300 Series
1117 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #778 background imageLoading...
Page #778 background image
Quality of Service (QoS) Commands
OL-32830-01 Command Line Interface Reference Guide 778
39
39.30 qos trust (Interface)
Use the qos trust Interface (Ethernet, Port Channel) Configuration mode command
to enable port trust state while the system is in the basic QoS mode. Use the no
form of this command to disable the trust state on each port.
Syntax
qos trust
no qos trust
Parameters
N/A
Default Configuration
Each port is enabled while the system is in basic mode.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
Example
The following example configures gi11 to the default trust state.
switchxxxxxx(config)#
interface
gi11
switchxxxxxx(config-if)#
qos trust
39.31 qos cos
Use the qos cos Interface (Ethernet, Port Channel) Configuration mode command
to define the default CoS value of a port. Use the no form of this command to
restore the default configuration.
Syntax
qos cos
default-cos
no qos cos

Table of Contents

Other manuals for Cisco 300 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 300 Series and is the answer not in the manual?

Cisco 300 Series Specifications

General IconGeneral
ModelCisco 300 Series
CategorySwitch
DimensionsVaries by model
WeightVaries by model
Power over Ethernet (PoE)Available on select models
ManagementWeb-based GUI, SNMP, CLI
VLANsUp to 256
Security FeaturesACLs, 802.1X, Port Security
Humidity10% to 90% non-condensing
Ports8, 16, 24, 48

Related product manuals