Cisco 300 Series User Manual

IPv6 First Hop Security
511 OL-32830-01 Command Line Interface Reference Guide
25
Parameters
• policy-name —The IPv6 First Hop Security policy name (up to 32
characters).
Default Configuration
The IPv6 First Hop Security default policy is applied.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
Use this command to attach an IPv6 First Hop Security policy to a VLAN.
If a policy specified by the policy-name argument is not defined, the command is
rejected.
Use the no form of the command to return to detach the current policy and to
reattach the default policy. The no form of the command does not have an effect if
the default policy was attached.
Example
In the following example, the IPv6 First Hop Security policy policy1 is attached to
VLAN 100:
switchxxxxxx(config)# interface vlan 100
switchxxxxxx(config-if)# ipv6 first hop security attach-policy policy1
switchxxxxxx(config-if)# exit
25.21 ipv6 first hop security logging packet
drop
To globally enable the logging of dropped packets by the IPv6 First Hop Security
feature, use the ipv6 first hop security logging packet drop command in Global
Configuration mode. To return to the default, use the no form of this command.
Syntax
ipv6 first hop security logging packet drop

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48