Cisco 300 Series

Ethernet Configuration Commands
405 OL-32830-01 Command Line Interface Reference Guide
18
Example
The following example displays the configuration of all configured interfaces:
switchxxxxxx# show interfaces configuration
Flow Admin Back Mdix
Port Type Duplex Speed Neg control State Pressure Mode
------ --------- ------ ----- -------- ------- ----- -------- ----
gi11 1G-Copper Full 10000 Disabled Off Up Disabled Off
gi12 1G-Copper Full 1000 Disabled Off Up Disabled Off
Flow Admin
PO Type Speed Neg Control State
------ ------ ----- -------- ------- -----
Po1 Disabled Off Up
18.19 show interfaces status
To display the status of all interfaces or of a specific interface, use the show
interfaces status Privileged EXEC mode command.
Syntax
show interfaces status
[interface-id | detailed ]
Parameters
• interface-id—(Optional) Specifies an interface ID. The interface ID can be
one of the following types: Ethernet port or port-channel.
• detailed—(Optional) Displays information for non-present ports in addition
to present ports.
Command Mode
Privileged EXEC mode
Default Configuration
Display for all interfaces. If detailed is not used, only present ports are displayed.