EasyManuals Logo

Cisco 300 Series User Manual

Cisco 300 Series
1117 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #634 background imageLoading...
Page #634 background image
Link Aggregation Control Protocol (LACP) Commands
OL-32830-01 Command Line Interface Reference Guide 634
28
28.2 lacp system-priority
To set the system priority, use the lacp system-priority Global Configuration mode
command. To restore the default configuration, use the no form of this command.
Syntax
lacp system-priority
value
no lacp system-priority
Parameters
value—Specifies the system priority value. (Range: 1–65535)
Default Configuration
The default system priority is 1.
Command Mode
Global Configuration mode
Example
The following example sets the system priority to 120.
switchxxxxxx(config)#
lacp system-priority 120
28.3 lacp timeout
To assign an administrative LACP timeout to an interface, use the lacp timeout
Interface (Ethernet) Configuration mode command. To restore the default
configuration, use the no form of this command.
Syntax
lacp timeout
{long | short}
no lacp timeout
Parameters
• long—Specifies the long timeout value.

Table of Contents

Other manuals for Cisco 300 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 300 Series and is the answer not in the manual?

Cisco 300 Series Specifications

General IconGeneral
ModelCisco 300 Series
CategorySwitch
DimensionsVaries by model
WeightVaries by model
Power over Ethernet (PoE)Available on select models
ManagementWeb-based GUI, SNMP, CLI
VLANsUp to 256
Security FeaturesACLs, 802.1X, Port Security
Humidity10% to 90% non-condensing
Ports8, 16, 24, 48

Related product manuals