Cisco 300 Series

37
OL-32830-01 Command Line Interface Reference Guide 736
Port Channel Commands
1
37.1 channel-group
To associate a port with a port-channel, use the channel-group Interface (Ethernet)
Configuration mode command. To remove a port from a port-channel, use the no
form of this command.
Syntax
channel-group
port-channel mode {on | auto}
no channel-group
Parameters
• port-channel—Specifies the port channel number for the current port to
join.
• mode—Specifies the mode of joining the port channel. The possible values
are:
- on—Forces the port to join a channel without an LACP operation.
- auto—Forces the port to join a channel as a result of an LACP operation.
Default Configuration
The port is not assigned to a port-channel.
Command Mode
Interface (Ethernet) Configuration mode
Default mode is on.