Cisco 300 Series User Manual

ACL Commands
OL-32830-01 Command Line Interface Reference Guide 132
4
switchxxxxxx(config-mac-al)# exit
switchxxxxxx(config)# interface gi1 1
switchxxxxxx(config-if)# service-acl input server-acl default-action deny-any
4.11 time-range
Use the time-range Global Configuration mode command to define time ranges for
different functions. In addition, this command enters the Time-range Configuration
mode. All commands after this one refer to the time-range being defined.
This command sets a time-range name. Use the absolute and periodic commands
to actually configure the time-range.
Use the no form of this command to remove the time range from the device.
Syntax
time-range
time-range-name
no time-range time-range-name
Parameters
time-range-name—Specifies the name for the time range. (Range: 1–32
characters)
Default Configuration
No time range is defined
Command Mode
Global Configuration mode
User Guidelines
After adding the name of a time range with this command, use the absolute and
periodic commands to actually configure the time-range. Multiple periodic
commands are allowed in a time range. Only one absolute command is allowed.
If a time-range command has both absolute and periodic values specified, then
the periodic items are evaluated only after the absolute start time is reached, and
are not evaluated again after the absolute end time is reached.
All time specifications are interpreted as local time.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48