Cisco 300 Series

Virtual Local Area Network (VLAN) Commands
OL-32830-01 Command Line Interface Reference Guide 1068
56
56.18 switchport general ingress-filtering
disable
Use the switchport general ingress-filtering disable Interface Configuration mode
command to disable port ingress filtering (no packets are discarded at the ingress)
on a general port. Use the no form of this command to restore the default
configuration.
Syntax
switchport general ingress-filtering disable
no switchport general ingress-filtering disable
Parameters
N/A
Default Configuration
Ingress filtering is enabled.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
Example
The following example disables port ingress filtering on gi11.
switchxxxxxx(config)# interface gi1 1
switchxxxxxx(config-if)# switchport mode general
switchxxxxxx(config-if)# switchport general ingress-filtering disable
56.19 switchport general
acceptable-frame-type
The switchport general acceptable-frame-type Interface Configuration mode
command configures the types of packets (tagged/untagged) that are filtered
(discarded) on the interface. Use the no form of this command to return ingress
filtering to the default.