Cisco 300 Series

Virtual Local Area Network (VLAN) Commands
1067 OL-32830-01 Command Line Interface Reference Guide
56
Syntax
switchport general pvid
vlan-id
no switchport general pvid
Parameters
• vlan-id —Specifies the Port VLAN ID (PVID).
Default Configuration
The PVID is the Default VLAN PVID.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
Examples
Example 1 - The following example sets the gi12 PVID to 234.
switchxxxxxx(config)# interface gi12
switchxxxxxx(config-if)# switchport general pvid 234
Example 2 - The following example performs the following:
• Adds VLANs 2&3 as tagged, and VLAN 100 as untagged to gi14
• Defines VID 100 as the PVID
switchxxxxxx(config)# interface gi14
switchxxxxxx(config-if)# switchport mode general
switchxxxxxx(config-if)# switchport general allowed vlan add 2-3 tagged
switchxxxxxx(config-if)# switchport general allowed vlan add 100 untagged
switchxxxxxx(config-if)# switchport general pvid 100
switchxxxxxx(config-if)# exit