Cisco 300 Series User Manual

Power over Ethernet (PoE) Commands
OL-32830-01 Command Line Interface Reference Guide 730
36
Default Configuration
The default value is the maximum power allowed in the specific working mode:
15.4W in case of AF port and 30W in case of AT port
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
The operational power limit is the minimum of the configured power limit value
and the maximum power capability on port. For example, if the configured value is
higher than 15.4W on a PoE port, the operational power limit is 15.4W.
Example
The following example sets inline power on a port.
switchxxxxxx(config)# interface gi1 1
switchxxxxxx(config-if)# power inline limit 2222
36.9 power inline limit-mode
To set the power limit mode of the system, use the power inline limit-mode Global
Configuration mode command. To return to default, use the no form of this
command.
Syntax
power inline limit-mode
{class |
port
}
no power inline limit-mode
Parameters
• class—The power limit of a port is based on the class of the PD (Power
Device) as detected during the classification process
• port—The power limit of a port is fixed regardless of the class of the
discovered PD.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48