Cisco 300 Series

Virtual Local Area Network (VLAN) Commands
1069 OL-32830-01 Command Line Interface Reference Guide
56
Syntax
switchport general acceptable-frame-type {tagged-only | untagged-only | all}
no switchport general acceptable-frame-type
Parameters
• tagged-only—Ignore (discard) untagged packets and priority-tagged
packets.
• untagged-only—Ignore (discard) VLAN-tagged packets (not including
priority-tagged packets)
• all—Do not discard packets untagged or priority-tagged packets.
Default Configuration
All frame types are accepted at ingress (all).
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
Example
The following example configures port gi13 to be in general mode and to discard
untagged frames at ingress.
switchxxxxxx(config)# interface gi1 3
switchxxxxxx(config-if)# switchport mode general
switchxxxxxx(config-if)# switchport general acceptable-frame-type tagged-only
56.20 switchport customer vlan
Use the switchport customer vlan Interface Configuration mode command to set
the port's VLAN when the interface is in customer mode (set by the switchport
mode command). Use the no form of this command to restore the default
configuration.
Syntax
switchport customer vlan
vlan-id
no switchport customer vlan