Cisco 300 Series User Manual

GARP VLAN Registration Protocol (GVRP) Commands
OL-32830-01 Command Line Interface Reference Guide 426
20
20.2 gvrp enable (Global)
To enable the Generic Attribute Registration Protocol (GARP) VLAN Registration
Protocol (GVRP) globally, use the gvrp enable Global Configuration mode
command. To disable GVRP on the device, use the no form of this command.
Syntax
gvrp enable
no gvrp enable
Parameters
This command has no arguments or keywords.
Default Configuration
GVRP is globally disabled.
Command Mode
Global Configuration mode
Example
The following example enables GVRP globally on the device.
switchxxxxxx(config)# gvrp enable
20.3 gvrp enable (Interface)
To enable GVRP on an interface, use the gvrp enable Interface (Ethernet, Port
Channel) Configuration mode command. To disable GVRP on an interface, use the
no form of this command.
Syntax
gvrp enable
no gvrp enable

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48