Cisco 300 Series

Ethernet Configuration Commands
415 OL-32830-01 Command Line Interface Reference Guide
18
Parameters
This command has no arguments or keywords.
Default Configuration
Disabled
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
Use the storm-control include-multicast Interface Configuration command to count
Multicast packets and optionally unknown Unicast packets in the storm control
calculation.
Example
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# storm-control broadcast enable
18.27 storm-control broadcast level
To configure the maximum rate of broadcast, use the storm-control broadcast
level Interface (Ethernet) Configuration mode command. To return to default, use
the no form of this command.
Syntax
storm-control broadcast level {
level | kbps kbps }
no storm-control broadcast level
Parameters
• level—Suppression level in percentage. Block the flooding of storm packets
when the value specified for level is reached. (Range 1-100)
• kbps—Maximum of kilobits per second of Broadcast traffic on a port.
(Range 3500 –100000)