Cisco 300 Series User Manual

58
OL-32830-01 Command Line Interface Reference Guide 1110
Web Server Commands
1
58.1 ip https certificate
To configure the active certificate for HTTPS, use the ip https certificate Global
Configuration mode command. To restore the default configuration, use the no
form of this command.
Syntax
ip https certificate
number
no ip https certificate
Parameters
number—Specifies the certificate number. (Range: 1–2)
Default Configuration
The default certificate number is 1.
Command Mode
Global Configuration mode
User Guidelines
First, use crypto certificate generate to generate one or two HTTPS certificates.
Then use this command to specify which is the active certificate.
Example
The following example configures the active certificate for HTTPS.
switchxxxxxx(config)# ip https certificate 2

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48