Clock Commands
OL-32830-01 Command Line Interface Reference Guide 250
9
Polling: enabled
Encryption Key: disabled
Broadcast Clients: enabled for IPv4 and IPv6
Anycast Clients: disabled
No Broadcast Interfaces
Source IPv4 interface: vlan 1
Source IPv6 interface: vlan 10
9.22 show sntp status
To display the SNTP servers status, use the show sntp status command in
Privileged EXEC mode.
Syntax
show sntp status
Parameters
N/A
Default Configuration
N/A
Command Mode
Privileged EXEC mode
Example
The following example displays the SNTP servers status:
switchxxxxxx#
show sntp status
Clock is synchronized, stratum 4, reference is 176.1.1.8, unicast
Reference time is afe2525e.70597b34 (00:10:22.438 PDT Jul 5 1993)
Unicast servers:
Server: 176.1.1.8
Source: DHCPv4 on VLAN 1
Status: Up
Last response: 19:58:22.289 PDT Feb 19 2005
To Next Page
Loading...
