Cisco 300 Series

Voice VLAN Commands
OL-32830-01 Command Line Interface Reference Guide 1106
57
57.9 voice vlan cos mode
To select the OUI voice VLAN Class of Service (CoS) mode, use the voice vlan cos
mode Interface Configuration mode command. To return to the default, use the no
form of this command.
Syntax
voice vlan cos mode {
src | all }
no voice vlan cos mode
Parameters
• src—QoS attributes are applied to packets with OUIs in the source MAC
address. See the User Guidelines of voice vlan oui-table.
• all—QoS attributes are applied to packets that are classified to the Voice
VLAN.
Default Configuration
The default mode is src.
Command Mode
Interface Configuration mode
Example
The following example applies QoS attributes to voice packets.
switchxxxxxx(config-if)# voice vlan cos mode all
57.10 voice vlan cos
To set the OUI Voice VLAN Class of Service (CoS), use the voice vlan cos Global
Configuration mode command. To restore the default configuration, use the no
form of this command.
Syntax
voice vlan
cos cos [ remark ]