Cisco 300 Series User Manual

Quality of Service (QoS) Commands
761 OL-32830-01 Command Line Interface Reference Guide
39
CoS value 6 is mapped to queue 8
CoS value 7 is mapped to queue 7
The default CoS value mapping to 4 queues is as follows:
CoS value 0 is mapped to queue 1.
CoS value 1 is mapped to queue 1.
CoS value 2 is mapped to queue 2.
CoS value 3 is mapped to queue 3.
CoS value 4 is mapped to queue 3.
CoS value 5 is mapped to queue 4.
CoS value 6 is mapped to queue 4.
CoS value 7 is mapped to queue 4.
Command Mode
Global Configuration mode
User Guidelines
Use this command to distribute traffic to different queues.
Example
The following example maps CoS value 4 and 6 to queue 2.
switchxxxxxx(config)# wrr-queue cos-map 2 4 6
39.18 wrr-queue bandwidth
Use the wrr-queue bandwidth Global Configuration mode command to assign
Weighted Round Robin (WRR) weights to egress queues. The weight ratio
determines the frequency at which the packet scheduler removes packets from
each queue. Use the no form of this command to restore the default configuration.
Syntax
wrr-queue bandwidth
weight1 weight2 ... weighting

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48