Cisco 300 Series User Manual

Link Layer Discovery Protocol (LLDP) Commands
663 OL-32830-01 Command Line Interface Reference Guide
30
Example
The following example sets the interval for sending LLDP updates to 60 seconds.
switchxxxxxx(config)# lldp timer 60
30.21 lldp transmit
To enable transmitting LLDP on an interface. use the no form of this command to
stop transmitting LLDP on an interface, use the lldp transmit Interface (Ethernet)
Configuration mode command.
Syntax
lldp transmit
no lldp transmit
Parameters
This command has no arguments or keywords.
Default Configuration
Enabled
Command Mode
Interface (Ethernet) Configuration mode
switchxxxxxx(config-if)#
User Guidelines
LLDP manages LAG ports individually. LLDP sends separate advertisements on
each port in a LAG.
LLDP operation on a port is not dependent on the STP state of a port. I.e. LLDP
frames are sent on blocked ports.
If a port is controlled by 802.1x, LLDP operates only if the port is authorized.
Example
switchxxxxxx(config)# interface gi11

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48