Cisco 300 Series User Manual

Smartport Commands
847 OL-32830-01 Command Line Interface Reference Guide
44
• parameter-name value —Specifies the parameter name and its value. These
are the parameters of the built-in or user-defined macro defined in the
macro auto user smartport macro command
Default Configuration
The default value of parameter $native_vlan of the built-in Smartport macros is 1.
For other parameters, the default value is the parameter’s default value. For
instance, if the parameter is the native VLAN, the default value is the default native
VLAN.
Command Mode
Global Configuration mode
User Guidelines
By default, each Smartport type is associated with a pair of built-in macros: a
macro that applies the configuration and the anti macro (no macro) to remove the
configuration. The Smartport types are the same as the name of the
corresponding built-in Smartport macros, with the anti macro prefixed with no_.
The value of the parameter $voice_vlan cannot be changed by this command.
Example
To change the parameters of a built-in macro:
switchxxxxxx(config)# macro auto built-in parameters switch $native_vlan 2
44.12 show macro auto processing
The show macro auto processing EXEC mode command displays information
about which protocols (CDP/LLDP) are enabled and which device types can be
detected automatically.
Syntax
show macro auto processing
Parameters
This command has no arguments or keywords.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48