Cisco 300 Series

IP Addressing Commands
455 OL-32830-01 Command Line Interface Reference Guide
22
Command Mode
Global Configuration mode
Default Configuration
No default gateway is defined.
User Guidelines
Use the ip default-gateway command to defines a default gateway (default route).
The ip default-gateway command adds the default route with metric of 1.
Use the no ip default-gateway
ip-address command to delete one default
gateway.
Use the no ip default-gateway command to delete all default gateways.
Example
The following example defines default gateway 192.168.1.1.
switchxxxxxx(config)# ip default-gateway 192.168.1.1
22.5 show ip interface
Use the show ip interface EXEC mode command to display the usability status of
configured IP interfaces.
Syntax
show ip interface [i
nterface-id ]
Parameters
• interface-id —Specifies an interface ID on which IP addresses are defined.
Default Configuration
All IP addresses.
Command Mode
User EXEC mode