Cisco 300 Series User Manual

IPv6 First Hop Security
OL-32830-01 Command Line Interface Reference Guide 546
25
25.45 ipv6 neighbor binding logging
To globally enable the logging of Binding table main events, use the ipv6 neighbor
binding logging command in Global Configuration mode. To disable this feature,
use the no form of this command.
Syntax
ipv6 neighbor binding logging
no ipv6 neighbor binding logging
Parameters
N/A
Default Configuration
Binding table events are not logged.
Command Mode
Global Configuration mode
User Guidelines
This command enables the logging of the following Binding table events:
• An entry is inserted into the Binding table.
• A Binding table entry was updated.
• A Binding table entry was deleted from the Binding table.
• A Binding table entry was not inserted into the Binding table, possibly
because the maximum number of entries has been reached or because of
Binding table overflow.
Example
The following example shows how to enable Binding table event logging:
switchxxxxxx(config)# ipv6 neighbor binding logging

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48