Cisco 300 Series User Manual

DHCP Server Commands
301 OL-32830-01 Command Line Interface Reference Guide
12
12.22 show ip dhcp declined
To display the specific declined address or all of the declined addresses on the
DHCP server, use the show ip dhcp declined command in User EXEC mode.
Syntax
show ip dhcp declined
[ ip-address ]
Parameters
• ip-address —(Optional) Specifies the IP address.
Command Mode
User EXEC mode
Example
The following example displays the output of various forms of this command:
switchxxxxxx# show ip dhcp declined
DHCP server enabled
The number of declined entries is 2
IP address Hardware address
172.16.1.11 00a0.9802.32de
172.16.3.254 02c7.f800.0422
switchxxxxxx# show ip dhcp declined 172.16.1.11
DHCP server enabled
The number of declined entries is 2
IP address Hardware address
172.16.1.11 00a0.9802.32de

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48