Cisco 300 Series

ACL Commands
137 OL-32830-01 Command Line Interface Reference Guide
4
• time-range-active—Shows only the Access Control Entries (ACEs) whose
time-range is currently active (including those that are not associated with
time-range).
Command Mode
Privileged EXEC mode
Example
switchxxxxxx# show access-lists
Standard IP access list 1
Extended IP access list ACL2
permit 234 172.30.19.1 0.0.0.255 any
priority 20 time-range weekdays
permit 234 172.30.23.8 0.0.0.255 any priority 40 time-range weekdays
switchxxxxxx# show access-lists time-range-active
Extended IP access list ACL1
permit 234 172.30.40.1 0.0.0.0 any priority 20
permit 234 172.30.8.8 0.0.0.0 any priority 40
Extended IP access list ACL2
permit 234 172.30.19.1 0.0.0.255 any priority 20time-range weekdays
switchxxxxxx# show access-lists ACL1
Extended IP access list ACL1
permit 234 172.30.40.1 0.0.0.0 any priority 20
permit 234 172.30.8.8 0.0.0.0 any priority 40
4.16 show interfaces access-lists
Use the show interfaces access-lists Privileged EXEC mode command to display
access lists (ACLs) applied on interfaces.
Syntax
show interfaces access-lists
[interface-id]