Cisco 300 Series User Manual

Link Layer Discovery Protocol (LLDP) Commands
OL-32830-01 Command Line Interface Reference Guide 652
30
Parameters
• coordinate data —Specifies the location data as coordinates in
hexadecimal format.
• civic-address data —Specifies the location data as a civic address in
hexadecimal format.
• ecs-elin data —Specifies the location data as an Emergency Call Service
Emergency Location Identification Number (ECS ELIN) in hexadecimal
format.
• data—Specifies the location data in the format defined in ANSI/TIA 1057:
dotted hexadecimal data: Each byte in a hexadecimal character string is
two hexadecimal digits. Bytes are separated by a period or colon. (Length:
coordinate: 16 bytes. Civic-address: 6-160 bytes. Ecs-elin: 10-25 bytes)
Default Configuration
The location is not configured.
Command Mode
Interface (Ethernet) Configuration mode
Example
The following example configures the LLDP MED location information on gi12 as a
civic address.
switchxxxxxx(config)# interface gi12
switchxxxxxx(config-if)# lldp med location civic-address 616263646566
30.10 lldp med network-policy (global)
To define a LLDP MED network policy, use the lldp med network-policy Global
Configuration mode command.For voice applications, it is simpler to use lldp med
network-policy voice auto.
The lldp med network-policy command creates the network policy, which is
attached to a port by lldp med network-policy (interface).
The network policy defines how LLDP packets are constructed.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48