Cisco 300 Series

Ethernet Configuration Commands
409 OL-32830-01 Command Line Interface Reference Guide
18
18.22 show interfaces counters
To display traffic seen by all the physical interfaces or by a specific interface, use
the show interfaces counters Privileged EXEC mode command.
Syntax
show interfaces counters
[interface-id | detailed ]
Parameters
• interface-id—(Optional) Specifies an interface ID. The interface ID can be
one of the following types: Ethernet port or port-channel.
• detailed—(Optional) Displays information for non-present ports in addition
to present ports.
Default Configuration
Display counters for all interfaces. If detailed is not used, only present ports are
displayed.
Command Mode
Privileged EXEC mode
Example
The following example displays traffic seen by all the physical interfaces.
switchxxxxxx# show interfaces counters gi11
Port InUcastPkts InMcastPkts InBcastPkts InOctets
---------- ------------ ------------ ------------ ------------
gi11 0 0 0 0
Port OutUcastPkts OutMcastPkts OutBcastPkts OutOctets
---------- ------------ ------------ ------------ ------------
gi11 0 1 35 7051
Alignment Errors: 0
FCS Errors: 0
Single Collision Frames: 0