Cisco 300 Series

CDP Commands
OL-32830-01 Command Line Interface Reference Guide 216
8
Parameters
• interface-id —Interface ID.
Command Mode
Privileged EXEC mode
Example
switchxxxxxx# show cdp interface gi11
CDP is globally enabled
CDP log duplex mismatch
Globally is enabled
Per interface is enabled
CDP log voice VLAN mismatch
Globally is enabled
Per interface is enabled
CDP log native VLAN mismatch
Globally is disabled
Per interface is enabled
gi11 is Down, CDP is enabled
Sending CDP packets every 60 seconds
Holdtime is 180 seconds
8.19 show cdp neighbors
The show cdp neighbors Privileged EXEC mode command displays information
about neighbors kept in the main or secondary cache.
Syntax
show cdp neighbors [
interface-id ] [detail | secondary]
Parameters
• interface-id —Displays the neighbors attached to this port.
• detail—Displays detailed information about a neighbor (or neighbors) from
the main cache including network address, enabled protocols, hold time,
and software version.