Cisco 300 Series User Manual

Smartport Commands
839 OL-32830-01 Command Line Interface Reference Guide
44
Parameters
This command has no arguments or keywords.
Default Configuration
None
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
User Guidelines
When a Smartport macro fails at an interface, the Smartport type of the interface
becomes Unknown. You must diagnose the reason for the failure on the interface
and/or Smartport macro, and correct the error. Before you or Auto Smartport are
allowed to reapply the desired Smartport macro, you must reset the interface
using the macro auto resume command, which changes the Smartport type of the
interface to default.Then you can run the macro auto trunk refresh command.
Example
Changes the Smartport type from unknown to default and resumes the Smartport
feature on port 1.
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# macro auto resume
44.5 macro auto persistent
The macro auto persistent Interface Configuration mode command sets the
interface as a Smartport persistent interface. The no format of the command
returns it to default.
Syntax
macro auto persistent
no macro auto persistent
Parameters
This command has no arguments or keywords.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48