Cisco 300 Series User Manual

DHCP Snooping Commands
331 OL-32830-01 Command Line Interface Reference Guide
13
13.24 ip arp inspection list create
Use the ip arp inspection list create Global Configuration mode command to
create a static ARP binding list and enters the ARP list configuration mode. Use the
no form of this command to delete the list.
Syntax
ip arp inspection list create
name
no ip arp inspection list create name
Parameters
• name —Specifies the static ARP binding list name. (Length: 1–32
characters).
Default Configuration
No static ARP binding list exists.
Command Mode
Global Configuration mode
User Guidelines
Use the ip arp inspection list assign command to assign the list to a VLAN.
Example
The following example creates the static ARP binding list ‘servers’ and enters the
ARP list configuration mode.
switchxxxxxx(config)# ip arp inspection list create servers
13.25 ip mac
Use the ip mac ARP-list Configuration mode command to create a static ARP
binding. Use the no form of this command to delete a static ARP binding.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48