Cisco 300 Series User Manual

Power over Ethernet (PoE) Commands
729 OL-32830-01 Command Line Interface Reference Guide
36
36.7 power inline traps enable
To enable inline power traps, use the power inline traps enable Global
Configuration mode command. To disable traps, use the no form of this command.
Syntax
power inline traps enable
no power inline traps enable
Default Configuration
Inline power traps are disabled.
Command Mode
Global Configuration mode
Example
The following example enables inline power traps.
switchxxxxxx(config)# power inline traps enable
36.8 power inline limit
To configure the power limit per port on an interface, use the power inline limit
Interface Configuration mode command. To return to default, use the no form of the
command.
Syntax
power inline limit
power
no power inline limit
Parameters
power—States the port power consumption limit in Milliwatts (Range:
0-15400 in case of AF port and 0-30000 in case of AT port)

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48