Cisco 300 Series User Manual

MLD Snooping Commands
711 OL-32830-01 Command Line Interface Reference Guide
34
Example
switchxxxxxx(config)# ipv6 mld snooping vlan 1 mrouter learn pim-dvmrp
34.8 ipv6 mld snooping vlan mrouter interface
To define a port that is connected to a Multicast router port, use the ipv6 mld
snooping mrouter interface command in Global Configuration mode. To return to
the default, use the no form of this command.
Syntax
ipv6 mld snooping
vlan vlan-id mrouter interface interface-list
no ipv6 mld snooping vlan vlan-id mrouter interface interface-list
Parameters
• vlan-id —Specifies the VLAN.
• interface-list —Specifies a list of interfaces. The interfaces can be from one
of the following types: port or port-channel.
Default Configuration
No ports defined
Command Mode
Global Configuration mode
User Guidelines
This command may be used in conjunction with the bridge multicast forward-all
command, which is used in older versions to statically configure a port as a
Multicast router.
A port that is defined as a Multicast router port receives all MLD packets (reports
and queries) as well as all Multicast data.
You can execute the command before the VLAN is created and for a range of ports
as shown in the example.
Example
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)#
ipv6 mld snooping vlan 1 mrouter interface gi11-4

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48