Cisco 300 Series User Manual

RADIUS Commands
OL-32830-01 Command Line Interface Reference Guide 790
40
Example
The following example specifies a RADIUS server host with IP address
192.168.10.1, authentication request port number 20, and a 20-second timeout
period.
switchxxxxxx(config)# radius-server host 192.168.10.1 auth-port 20 timeout 20
40.2 radius-server key
Use the radius-server key Global Configuration mode command to set the
authentication key for RADIUS communications between the device and the
RADIUS daemon. Use the no form of this command to restore the default
configuration.
Syntax
radius-server key [
key-string ]
encrypted radius-server key [
encrypted-key-string ]
no radius-server key
Parameters
• key-string —Specifies the authentication and encryption key for all RADIUS
communications between the device and the RADIUS server. This key must
match the encryption used on the RADIUS daemon. (Range: 0–128
characters)
• encrypted-key-string —Same as the key-string parameter, but the key is in
encrypted form.
Default Configuration
The key-string is an empty string.
Command Mode
Global Configuration mode

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48