EasyManuals Logo

Cisco 300 Series User Manual

Cisco 300 Series
1117 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #639 background imageLoading...
Page #639 background image
29
OL-32830-01 Command Line Interface Reference Guide 639
Line Commands
0
29.1 autobaud
To configure the line for automatic baud rate detection (autobaud), use the
autobaud command in Line Configuration mode.
Use the no form of this command to disable automatic baud rate detection.
Syntax
autobaud
no autobaud
Parameters
This command has no arguments or keywords.
Default Configuration
Automatic baud rate detection is enabled.
Command Mode
Line Configuration Mode
User Guidelines
When this command is enabled, it is activated as follows: connect the console to
the device and press the Enter key twice. The device detects the baud rate
automatically.
Example
The following example enables autobaud.
switchxxxxxx(config)#
line console
switchxxxxxx(config-line)#
autobaud

Table of Contents

Other manuals for Cisco 300 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 300 Series and is the answer not in the manual?

Cisco 300 Series Specifications

General IconGeneral
ModelCisco 300 Series
CategorySwitch
DimensionsVaries by model
WeightVaries by model
Power over Ethernet (PoE)Available on select models
ManagementWeb-based GUI, SNMP, CLI
VLANsUp to 256
Security FeaturesACLs, 802.1X, Port Security
Humidity10% to 90% non-condensing
Ports8, 16, 24, 48

Related product manuals