Cisco 300 Series User Manual

Clock Commands
239 OL-32830-01 Command Line Interface Reference Guide
9
Command Mode
Global Configuration mode
User Guidelines
Use the sntp broadcast client enable Interface Configuration mode command to
enable the SNTP Broadcast client on a specific interface.
After entering this command, you must enter the clock source command with the
sntp keyword for the command to be run. If this command is not run, the switch will
not synchronize with Broadcast servers.
Example
The following example enables SNTP Broadcast clients.
switchxxxxxx(config)# sntp broadcast client enable
9.12 sntp client enable
To enable the SNTP Broadcast and Anycast client, use the sntp client enable
command in Global Configuration mode. To restore the default configuration, use
the no form of this command.
Syntax
In switch mode:
sntp client enable
no sntp client enable
In router mode:
sntp client enable
interface-id
no sntp client enable interface-id
Parameters
• interface-id —Specifies an interface ID, which can be one of the following
types: Ethernet port, Port-channel or VLAN.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48