Cisco 300 Series User Manual

DHCP Server Commands
OL-32830-01 Command Line Interface Reference Guide 288
12
Default Configuration
DHCP hosts are not configured.
Command Mode
Global Configuration mode
User Guidelines
During execution of this command, the configuration mode changes to the DHCP
Pool Configuration mode. In this mode, the administrator can configure host
parameters, such as the IP subnet number and default router list.
Example
The following example configures station as the DHCP address pool:
switchxxxxxx(config)# ip dhcp pool host station
switchxxxxxx(config-dhcp)#
12.11 ip dhcp pool network
To configure a DHCP address pool on a DHCP Server and enter DHCP Pool
Network Configuration mode, use the ip dhcp pool network command in Global
Configuration mode. To remove the address pool, use the no form of this
command.
Syntax
ip dhcp pool network
name
no ip dhcp pool network name
Parameters
• name —Specifies the DHCP address pool name. It can be either a symbolic
string (such as ‘engineering’) or an integer (such as 8). (Length: 1–32
characters).
Default Configuration
DHCP address pools are not configured.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48